INTERNATIONALSTANDARDISO14130:1997 TECHNICAL CORRIGENDUM 1 TSo Published 2003-11-01 NTERNATIONAL ORGANIZATION FOR STANDARDIZATION ORGANISATION INTERNATIONALE DE NORMALISATION Fibre-reinforced plastic composites Determination of apparent interlaminar shear strength by short-beam method TECHNICAL CORRIGENDUM 1 Composites plastiques renforces de fibres -Determination de la résistance au cisaillement interlaminaire apparent par essai de flexion sur appuis rapprochés RECTIFICATIFTECHNIQUE1 Technical Corrigendum 1 to ISO 14130:1997 was prepared by Technical Committee ISO/TC 61, Plastics Subcommittee SC 13, Composites and reinforcement fibres. Page 1, Clause 2 Update the normative references as follows: plates, and delete the footnote. Replace Iso 5893:1993 by Iso 5893:2002, Rubber and plastics test equipment - Tensile, flexural and compression types (constant rate of traverse)Specification. Page 2, Definition 4.1 Replace "It is calulated from the relationship given in 10.1" by "It is calulated from Equation (1) in 10.1". ICS83.120 Ref. No. ISO 14130:1997/Cor.1:2003(E) ?ISO2003-All rightsreserved ganization for Standardization 3rland No reproduction or networking permitted without license from IHS Not for Resale ISO 14130:1997/Cor.1:2003(E) Page 2, Definition 4.2 in megapascals (MPa)". Page 4, Subclause 6.2 Replace "in accordance with ISO 1268" by "in accordance with the relevant part of ISO 1268". Page 5, Subclause 9.2 Replace the existing text by the following: "Measure, at the mid-point of each test specimen, the width b and the thickness h of the specimen to the nearest 0,02 mm." Page 6, Subclause 9.7 In the note, replace “apparent interlaminar shear strength" both times it occurs by "apparent interlaminar shear stress". Page 6, Subclause 10.1 Replace the existing text by the following: equation: 3..F (1) 4~bh where F is the load, in newtons; b is the width, in millimetres, of the test specimen; h is the thickness, in millimetres, of the test specimen. Calculate the apparent interlaminar shear strength M, expressed in megapascals, using the following equation: 3~FM (2) where FM is the failure or maximum load, in newtons; b is the width, in millimetres, of the test specimen; h is the thickness, in millimetres, of the test specimen." @ ISO 2003 - All rights reserved Not for Resale ISO14130:1997/Cor.1:2003(E) Page 6, Subclause 10.3 Replace the existing text by the following: "Calculate the apparent interlaminar shear stress and shear strength to three significant figures." Page 7, Figure 4 Replace Figure 4 d) by the following figure: d) Plastic shear Unacceptable interlaminar shear failure 3 NoreproductionornetworkingpemitedwithoutlicensefromHS Not for Resale